Laurel-electronics QLS Quad Output 4-20 mA Current Loop - Manual Manuale Utente Scaricare il pdf (Pagina 4)

- 4 -

6. JUMPER SETTINGS

The four outputs are always 4-20 mA process loops. The

signal input can be 4-20 mA, 1-5V, 0-5V or 0-10V, as set

by jumpers adjacent to the signal input connector on the

circuit board. The factory default input setting is 4-20

mA. To change jumpers, remove power, then open the

case by removing the screws at the four corners of the

case. Store the unused jumper, if any, on an unused pin.

Jumper Positions:

4-20 mA ............................a + c

1-5V ....................................... d

0-5V .................................. b + f

0-10V .............................. a + e

7. ELECTRICAL CONNECTIONS

1 2 3 4 5 6 7 8

Nessun commento

Laurel-electronics QLS Quad Output 4-20 mA Current Loop - Manual Manuale Utente Pagina 4